My compliment to you is well deserved! Thank You!' Good product, great price, quick turnaround. It's one of those things that needs to be earned. “I'm not an easy go when it comes to compliments. Always run a test piece to see if you need to raise or lower the bit until you get a perfect fit. The easiest way to do this is to use the first piece that you cut as a 'set up block' to align with the corresponding bit. But, how do you set up the bit to make the corresponding groove, making sure that it aligns perfectly with the tongue? Thanks. It looks like you run the board through with the two cutters attached to make the tongue, which seems pretty straightforward. Do you have any instructions for using this router bit? There are two cutters, separated by a bearing, with another bearing on top, and then of course, the nut holding it all together. I have not used it but need to use if for a project. I have the WL-1484 Tongue and Groove Router bit 'set'. If you have further questions, you may also call us M-F 8-4 Central Time at 80.

WL-1338B has a cut length of 1-1/8', so it will work on either the 7/8' or 3/4' material. I'm wanting to tongue a groove 7/8 cedar for a porch ceiling, what 2 bits do I need? Can these bits be adjusted to use on 3/4 flooring boards? The only T&G bit for material that thin would be WL-1488-2. My hardwood flooring is 3/8 inch thick what size router but do I need to cut my groove The WL-1488-1 would work, but if you want the lower material removed from the joint the way the SC450 works, #55456 will work the same way. I am installing a 3/4” engineered hickory flooring that is going to require adding T&G ends to cuts and rips. I am looking for a T& G router set with a 1/2” shank that is the same profile as the Amana SC 450 shaper/cutter. WL-1338B will work for material up to 1-5/16'. Route-R-Joint™ Precision Dovetail SystemĬan this bit be used on 1 in thick stock?.

Tongue and groove router bits